SUPER CART MULE®         

Maximum Load capacity: 13,000 lbs  

Deep Cycle, 345 MINUNTE

RESERVE CAPACTY: 8hr OPERATING TIME

SPECIFICATIONS/FEATURES FOR MODELS:

CM20100-405 NON REMOTE/PCM7100-405/P/PM7200-405 THESE MODEL NUMBERS MEETS OR EXCEEDS Underwriters Laboratories CLASSIFICATION 583

MECHANICAL SPECIFICATIONS:

STATIC:

DIMENSIONS LENGTH....42" WIDTH..... 28" HEIGHT............. 47" (Less handle and tow bar)                          

TIRES (1) FRONT.......10"DIA. (2) REAR.......12" DIA. PNEUMATIC OPTIONAL FOAM FILLED TIRES                                

WEIGHT 680 lbs.                                                                                                                                                                

GROUND CLEARANCE 3.0" TIRES MOUNTED ON SIDES FOR LOWEST CG (center of Gravity) TO ELIMINATE TIP OVER OF UNIT.                                                                                                                                                            

WORKING LOAD MAX CARTS TO BE PUSHED OR PULLED IS 55 IN NORMAL CONDITIONS. THE MAX QUANTITY MAY BE LESS DEPENDING ON PARKING LOT CONDITIONS. PUSH OR PULL LBS 13,000 MAX

DUTY CYCLE 16 HOURS UNDER NORMAL CONDITIONS. SURFACE GRADE AND TEMPERATURE MAY AFFECT DAILY OPERATING TIME.

BRAKING:

BRAKES TYPES; 1.) DYNAMIC BRAKING FROM MOTOR 2.) STATIC GEAR REDUCTION BRAKING, AUTOMATIC BRAKING SINGLE START 40:1 LOCKING FORWARD & BACK DRIVE GEAR REDUCER

SYSTEM DRIVER:  

MOTOR U.L., CSA, ISO. WITH THERMAL OVERLOAD PROTECTION, 24V MOTOR. DIM 6.0 LENGTH 12.0  40 LBS 1800 RPM. DYNAMIC BRAKING TYPE PER U.L. 583 FURTHER MGF SPECIFICATIONS PROVIDED UPON REQUEST                                                                                                        

REAR WHEEL DRIVE DRIVE  DIFFERENTIAL, WITH 1” INCH DRIVE SHAFT AXEL. COMPLETE DRIVE SYSTEM FULLY SHIELDED FROM ENVIRONMENTAL HAZARDS BY 7 GAGE (.19) STEEL PER U.L. 583

CONSTRUCTION SPECIFICATIONS: 

FIBERGLASS OUTER ENCLOSURE, NOMINAL 0.1 INCH THICKNESS. FLAME RETARDANT ADDITIVES, ALUMINA TRIHYDRATE, AND DYDRATED ALUMINA. ENCLOSURE SECURED TO FRAME BY SCREWS. FIBERGLASS IMPACT TESTED, PER UL 583                                                                                                                                        

FRAME POWDER COATED ALL STEEL 7 GAGE (.19)  CONSTRUCTION. SEVEN ½ INCH. (VENTILATION HOLES ON EACH SIDE TO ALLOW  POSSIBLE GAS PRODUCED DURING BATTERY CHARGING TO ESCAPE. PER UL 583) ¼ INCH STEEL MOUNTING PLATE FOR REDUCER. 1/8 INCH POWDER COATED STEEL SQUARE TUBING FOR HANDLE.

OPERATING SPECIFICATIONS:

MANUAL OPERATION:

SPEED FACTORY SET; FORWARD DIRECTION ; REVERSE DIRECTION FOUR BUTTON WEATHER RESISTANT KEY PAD SECURED TO HANDLE ASSEMBLY.  FORWARD SPEED BUTTON #1= 1 MPH, FORWARD BUTTON #2= 2 MPH FORWARD BUTTON #3=3 MPH, REVERSE BUTTON #1= 1MPH

SIGNAL DEVICES FOR REMOTE UNIT OPTIONAL: SAFETY HORN  AUTOMATIC BRAKE LIGHT  BEACON STROBE LIGHT, AMBER, 100,000 CANDLE POWER.

ELECTRICAL SPECIFICATIONS:

OPERATING VOLTAGE   DEEP CYCLE, SEALED GEL TYPE, UL RECOGNIZED, FAA APPROVED, CONNECTED FOR 24 VDC OUTPUT 

BATTERY AND CHARGING SYSTEM:

BATTERY CHARGER GEL TYPE, UL/CSA, 120 VAC 60 HZ, AUTOMATIC SHUTDOWN WHEN BATTERIES HAVE BEEN FULLY CHARGED. RECHARGE TIME FROM NORMAL DISCHARGE APPROXIMATELY  8-10 HOURS.

SAFETY FEATURES:

WIRING EMPLOYED IN THE ASSEMBLY OF THE CART MULE IS LISTED R/C (AVLV2), 8 AWG WITH 5/64INCH. THICK INSULATION FOR BATTERY AND MOTOR CIRCUITS AND 22 AWG WITH 1/32 INCH THICK INSULATION FOR CONTROL AND SIGNAL CIRCUIT WIRING TESTED AND COMPLIES U.L 583

MOTOR U.L., CSA, ISO. WITH THERMAL OVERLOAD PROTECTION

INDIVIDUAL REMOTE FM RADIO SECURITY PROGRAMMING.                                                                        

BEACON STROBE LIGHT 100,00 CANDLE POWER

LIGHT TOWER ELEVATION AT EYE LEVEL OPTIONAL, STROBE LIGHT, BREAK LIGHT, DIAGNOSTICS FAULT INDICATOR PANEL, FOR A REMOTE UNIT A EMERGENCY SHUT OFF SWITCH, AND WARNING HORN  

OPTIONAL WARNING HORN FOR REMOTE UNIT IN MANUAL AND REMOTE

AUTOMATIC EMERGENCY STOP WHEN RELEASE OF FORWARD SPEED CONTROL BUTTON MANUAL AND REMOTE.

SECURITY SWITCH PREVENTS UNAUTHORIZED PERSONS FROM USING THE CART MULE, AND EMERGENCY REMOTE SHUT OFF SWITCH ON LIGHT TOWER .

DIAGNOSTIC FAULT INDICATOR LOW BATTERY DISPLAY PANEL. LOW BATTERY, BAD CONNECTION TO MOTOR, MOTOR HAS SORT CIRCUIT TO BATTERY CONNECTION, CONTROLLER FAULT, AND EXCESSIVE VOLTAGE TO CONTROLLER CAUSED BY POOR CONNECTION TO BATTERIES. TESTED PER UL 583

THIS CART MULE MODEL HAS BEEN TESTED AS A COMPLETE UNIT AND COMPLIES WITH U.L. 583

ADDITIONAL FEATURES   

WEATHER THE "CART MULE" WORKS WELL IN THE RAIN 0R SNOW.  (OPTIONAL SPECIAL TIRES RECOMMENDED FOR USE IN SNOW OR ICE.)

PROVIDED WITH A U.L. SAFETY TESTED PRODUCT, OSHA COMPLIANT OPERATORS TRAINING PROGRAM WITH COURSE MATERIALS AND SAFETY TEST.

PARTS LIST.

U.S. PATENT # 5,573,078 PATENT PENDING FOREIGN PATENTS APPLIED FOR ENVIRONMENTALLY SAFE MADE IN THE U. S. A. U.L. FILE NON-ACTIVE# E168179 U.L. FILE # AU3611 EE

This unit is built and tested to the standards of the USAF

The battery-operated Tug is designed specifically for short towing operations and the movement of fighter aircraft specifically

F-15 and F-16 and

equivalent equipment in congested areas. The Tug tow Air Craft Puller/Pusher is based on six

parameters: controllability, safety, ease-of-use, maneuverability, storability, and no emissions.

1. Controllability. The Motorized Military and Commercial

Air Craft Puller/Pusher controls the Air Craft
by a single person walking forward of the Tug
using the control keypad on the handle. The Air Craft Puller/Pusher
is equipped with two forward and two reverse speeds.

2. Safety. The Tug is equipped with
two braking systems and stop automatically once the
operator lets go of the handle.

3. Ease-of-use. Simple hookup and release of the aircraft
attachment and easy to grasp controls.

4. Maneuverability, Unit can pivot 180 degrees.

5. Storability, unit can be stored in any dry small
space with access to an electrical outlet for charging the
batteries.

6. No emissions. Unlike gas-driven vehicles, the unit
runs on gel-cell batteries and does not emit harmful
emissions. The Tug motorized mover unit is tough, quiet
running, and equipped with wheels that are sized for
maximum traction, wet or dry. The Air Craft Puller/Pusher
utilizes a heavy duty pintle hook attachment for towing

Commercial Jets, F-15, F-16 Fighter Jets or like equipment

such as Jet Engine Maintenance Carts, Start up Generators etc

for use in the hanger and flight line.      

Call for Quote

Availability: 4 to 6 weeks